The first-generation 1-Series is the BMW people actually use rather than polish in a garage. It is small, rear-wheel drive, and cheap enough to buy that owners take it to a track day without worrying about the miles. The factory seats were never built for that. On a car pushing fifteen years old the bolsters have usually gone soft, the cloth has thinned out, and the seating position sits higher than the chassis underneath it deserves.
A fitting frame changes both problems at once. Bolt a base-mount recliner to a frame built for this car and the seat drops lower, holds you properly through a corner, and stops sliding around on the motorway run to get there.
We stock a fitting frame for the first-generation 1-Series from two brands, and between them they cover every seat in this guide. A frame is the vehicle specific base that bolts to the floor in place of the standard runners, and it sets your final seat height. Which frame you buy decides which seats you can run, so this choice comes first. Neither of these frames applies to the second-generation F20 or F21 hatchback from 2012 onward, since that car uses a different floor entirely; we stock separate direct-fit frames for that generation, so get in touch and we will point you at the right one.
Part 00499080, £90.60 inc VAT, sold individually, RHD driver and passenger listed separately. Covers the first-generation 1-Series built from 2005 to 2011. Its own listing confirms it takes Sparco and Corbeau base mount seats.
Part 69.02-E87, £420.00 inc VAT, sold individually, RHD driver and passenger. This is Recaro's own direct-fit frame, listed specifically for the E87. If you drive the E81 three-door, E82 coupe or E88 convertible, ask us to confirm fitment before ordering.
Every reclining seat we sell bolts down through a base mount pattern, and on this car two of them matter. Sparco recliners use 345mm x 271mm, which is what the Sparco subframe is built around, and its own product listing confirms it also takes Corbeau base mount seats on the same pattern. The Recaro Sportster CS uses a different pattern again, 405mm x 290mm, and neither the Sparco subframe’s listing nor the Corbeau seats’ own fitment claims that pattern. For the Sportster CS, Recaro’s own E87 direct-fit frame is the route we sell on this car.
| Seat | Bolt pattern | Sparco subframe | Recaro E87 subframe |
|---|---|---|---|
| Sparco R100 | 345 x 271 | Fits | No |
| Sparco R500 | 345 x 271 | Fits | No |
| Corbeau Sportline RRS Low Base | 291 or 345 | Fits | No |
| Corbeau Sportline RRS Elite | 291 or 345 | Fits | No |
| Recaro Sportster CS | 405 x 290 | No | Fits |
The R100 is the recliner we fit into more first-generation 1-Series cars than anything else, and it is usually the sensible place to start. It is a compact seat with a simple recline mechanism, and Sparco list it as suitable for all waist sizes and for drivers both over and under six foot, which is a hard combination to find in a base mount recliner this price. On a hatchback the flat, open base also makes it easy to climb in and out of the back doors without catching a bolster on the way past.
Step up to the R500 and the shape stays forgiving but the backrest grows taller and the foam gets denser, so it holds its position better on a long motorway run before a track day. It comes in fabric or the wipe-clean Sky vinyl, both listed for 32 to 38 inch waists at all heights. Pick it over the R100 if the car is doing regular track evenings rather than the odd one and you want more upper body support without moving to a full bucket.
The Low Base version of the RRS buys back headroom that a hatchback roofline eats into once the seat drops onto a frame, which matters more on this car than people expect. It is drilled for both 291mm and 345mm, so it happens to bolt to the Sparco subframe just as readily as a Cobra frame would elsewhere, though on this car the Sparco subframe is the route we sell it on. Corbeau’s own sculpted backrest shape is firmer through the shoulders than either Sparco option, worth knowing if you have sat in both before.
The Elite is the same RRS shell with a noticeably better trim finish and the option list to match, which is where the extra money over the Low Base goes rather than into more support. If the 1-Series is doing daily duty as well as the odd trackday, the nicer materials earn their keep faster than they would on a car that only comes out at weekends. It shares the same dual 291mm and 345mm drilling as the Low Base, so it goes on the same Sparco subframe.
BMW owners ask for this seat more than any other we stock, and on a 1-Series it earns the reputation rather than living off it. The Sportster CS holds the shoulders and thighs firmly without the tight squeeze of a full bucket, so it stays comfortable on the drive there as well as on track. Recaro list it as suitable for all waist sizes and all heights, which is unusual for a seat with this much support, and the heated version is worth the extra if the car still does winter commuting. It uses a 405mm base mount, wider than either Sparco pattern, so it goes on Recaro’s own E87 direct-fit frame rather than the Sparco subframe.
Both frames bolt to the 1-Series’s factory seat mounting points, so there is no drilling on a standard floor. Torque the floor bolts properly and check seat belt buckle clearance before you drive, since a sport seat often sits the buckle somewhere new. Between seat and frame go the sliding runners, and they follow the same brand logic as the frames. One thing worth knowing before you order: both frames are listed per side, RHD driver and RHD passenger, so a pair means adding two to the basket.
| Your seat | Runners to order | Works on |
|---|---|---|
| Sparco R100 or R500 | Sparco sliding runner kit, £78.00 a pair | Sparco subframe |
| Corbeau RRS Low Base or Elite | Corbeau 345mm sliding runners, £117.60 a pair | Sparco subframe |
| Recaro Sportster CS | Endurance Recaro-compatible runner kit, £95.04 a seat, or Recaro's own double locking runners at £365.40 a pair | Recaro E87 subframe |
The first-generation 1-Series runs from 2004 to 2011 across the E81 three-door, E82 coupe, E87 five-door and E88 convertible. The Sparco subframe’s own listing covers the range as a whole. The Recaro subframe is listed specifically for the E87, so if your car is one of the other three body styles, tell us when you order and we will confirm it fits before anything ships. If your car is a 2012-onward F20 or F21, neither frame here applies, since that generation uses a different floor; ask us for the right frame instead.
| Seat | Bolt pattern | Waist | Height | Weight | Price inc VAT |
|---|---|---|---|---|---|
| Sparco R100 | 345 x 271 | All sizes | Over and under 6ft | Not published | From £282.00 |
| Sparco R500 | 345 x 271 | 32 to 38in | All heights | Not published | From £329.00 |
| Corbeau RRS Low Base | 291 or 345 | 32 to 38in | All heights | Not published | £498.00 |
| Corbeau RRS Elite | 291 or 345 | 32 to 38in | All heights | Not published | £720.00 |
| Recaro Sportster CS | 405 x 290 | All sizes | All heights | Not published | From £1,581.30 |
Prices include VAT and were correct on 15 August 2026. Where a weight says not published, the manufacturer does not give one and we will not guess it. Waist and height figures are the manufacturers’ published fitment ranges, if you are on a boundary, ask us before ordering.
Not on a standard floor. Both frames bolt to the factory seat mounting points. Torque the floor bolts properly and check the seat belt buckle clearance before you drive, because a sport seat often sits the buckle somewhere new.
No. The Sparco subframe's own listing confirms it takes Sparco and Corbeau base mount seats on the 345mm x 271mm pattern. The Sportster CS uses a wider 405mm x 290mm mount, so it needs Recaro's own E87 direct-fit frame instead.
The Sparco subframe's listing covers the first-generation car, 2005 to 2011, across the E81, E82, E87 and E88 body styles. It does not apply to the 2012-onward F20 or F21 hatchback, which uses a different floor entirely. We stock separate direct-fit frames for that generation, so ask us if that is your car.
The Recaro subframe is listed specifically for the E87. We would rather confirm it against your exact car before you order than guess, so send us your registration or VIN and we will check before anything ships.
Yes. A customer asked us the same question a while back and we wrote up the fuller answer in Choosing Aftermarket Sport Seats For Your BMW E87. This page is the shorter, frame-first version built around the routes we currently stock.
If it were my money: the R100 on the Sparco frame for a road car on a budget, because it does most of the job for the least outlay. The RRS Low Base if the roofline is eating into your headroom once the seat drops, or the Elite if the car is a daily as well as a track car and the nicer trim is worth it to you. And if other BMW owners keep telling you to get the Recaro, believe them, the Sportster CS is the seat people keep for years rather than swap out, it just needs its own frame to go on.
Every combination above bolts straight to the 1-Series’s factory mounting points, on the generation and body style each frame is actually listed for. If you are between two of these seats, unsure which body style you have, or between sizes, send us your details and we will talk it through before you spend anything.
The five reclining sport seats we rate for the Audi TT Mk1, with the Cobra Seats and Planted Technology frame routes that bolt each one straight to the factory mounting points.
The five reclining sport seats we rate for the Porsche 911 991, with the Cobra, Planted Technology and Recaro frame routes that bolt each one straight to the factory mounting points.
The five reclining sport seats we rate for the Volkswagen Golf Mk6, with the Cobra, Sparco and Planted Technology frame routes that bolt each one straight to the factory mounting points.
The five reclining sport seats we rate for the Volkswagen Scirocco MK3, with the Cobra, Sparco and Planted Technology frame routes that bolt each one straight to the factory mounting points.
The five reclining sport seats we rate for the Audi A6 (97 Onwards), with the Cobra frame route that bolts each one straight to the factory mounting points, plus why we do not sell the Planted bracket route on this generation.
The five reclining sport seats we rate for the first-generation BMW 1-Series, with the Sparco and Recaro frame routes that bolt each one straight to the factory mounting points.
Hundreds Of Products Ready Today. Dispatch/Collection 
