The Cobra Roadster 7 for the Fury kit car, a narrow fit bucket seat. Part number COBROAD7-FURY.
Decide the seat early in the build
On a kit car the seat is not the last thing you fit, it is one of the first things you should plan around. Where the driver sits sets the pedal position, the wheel position and the harness anchorage, and all three are far easier to get right before the car is finished than after.
If you are still building, tell us where you are up to. Getting the seat in your hands early is usually worth more than saving the money until the end.
The measurements
750mm high, 460mm across the shoulders, 720mm front to back, on a 400mm base, at 7kg.
The 400mm base is the figure that matters. That is the width down at floor level, between the sills and clear of the transmission tunnel, and it is what gets this seat into cars where a normal one will not go. Standard sports seats have a base in the 500mm to 560mm range and simply foul the tunnel or the sill top rails.
Measure your own car at floor level between the sill and the tunnel, and compare it to 400mm. If it is close, send us the figure and we will check it against a seat before you order.
Harness holes are an extra cost option and cannot be cut after trimming. On a kit car build a harness is close to certain, so take them.
Road and Track approved rather than FIA homologated. Base mount. Seat only.
