An OMP direct fit subframe for the Hyundai Coupe. Part number HC819.
Coupe here, Tiburon elsewhere
Same car, different name depending on the market. Worth knowing if you have been searching under one and finding nothing, and worth telling us which your paperwork says if the car is an import.
It sits on its own OMP part number with no siblings in the range, so there is nothing that carries over from a related model. Send us the registration and we will check it against the part.
The 2.7 V6 is the one that gets built
And they are cheap enough that a fair few get used properly rather than kept tidy. That is the case for a seat: these are cars people drive hard on a budget, where the standard item has usually done a lot of miles and stopped supporting anyone.
It is also a reasonably wide cabin by the standards of this list, so shell choice is less constrained here than on a Polo or a 500.
The frame
Steel, base mount, on the mounting points already in the floor. Nothing is drilled and the standard seats come out whole.
Two bolt patterns: 345mm by 271mm for Sparco, OMP and Corbeau base mount seats, and 405mm by 290mm for Recaro, from the multi-hole clusters at each corner.
Sold singly and handed, so order twice for both sides.
Will this fit my car?
This frame is made for the Hyundai Coupe. Chassis code and years matter more than the badge, as floor pans change between generations, so if your car sits near a changeover year, send us the registration and we will confirm before you order.
Which seats does it take?
It takes seats drilled 345mm x 271mm (the Sparco and OMP seat pattern) and 405mm x 290mm (the Recaro seat pattern). If your seat is not listed, tell us what you run and we will confirm the fit.
Do I keep fore-and-aft adjustment?
Only with a sliding runner between the frame and the seat, which is a separate part on OMP frames. If more than one person drives the car, budget for the runner. Our guide to sliding runners explains the options and widths.
Base mount or side mount, and does it matter?
This is a base-mount frame: the seat bolts down through its base, the simpler stack that suits seats with a flat bottom and keeps the install low-fuss. Our guide on base mount versus side mount explains the whole fitting stack.
Is this for the driver or passenger side?
Both sides are available on this listing, pick driver or passenger side at the point of order (sides listed are for right-hand-drive cars). Left-hand-drive car? Ask us, as the sides swap over and availability varies by model.
