An OMP direct fit subframe for the Ford Fiesta Mk4. Part number HC793-2669.
Shared with the Puma
The Ford Puma is built on the Mk4 Fiesta floor, which is why the two sit on the same HC793 stem. If you have seen a seat working in one, it carries over to the other.
Worth knowing, because the Puma is the less obvious of the two and people do not always think to look at Fiesta parts for it.
A long production run
The Mk4 covers a lot of trim and engine variants, and this frame is specific to the generation rather than to any one of them. Check the generation rather than the badge, and send us the registration if you would like it confirmed.
What you gain
These are old cars now, and the standard seat will have lost its foam and its side support long ago. A bucket here is not a marginal improvement, it is the difference between being held and not.
They are also cheap cars to build, which is exactly the argument for spending on the seat: it is the part you are in contact with for the whole session, and it is the part that carries over to the next car.
The frame
Steel, base mount, using the floor mounting points already in the car, so nothing is drilled.
Two bolt patterns from the multi-hole clusters at each corner: 345mm by 271mm for Sparco, OMP and Corbeau, 405mm by 290mm for Recaro. Sold singly and handed, so order twice for both sides.
Have you written anything useful for my car?
Yes: Top 5 reclining seat choices for your Ford Fiesta Mk6, including our fitting guide, and Top 5 reclining seat choices for your Ford Fiesta ST180, including our fitting guide. Those are written around the same car, from real fittings and customer questions, so they are worth a look before you decide.
Will this fit my car?
This frame is made for the Ford Fiesta Mk4. Chassis code and years matter more than the badge, as floor pans change between generations, so if your car sits near a changeover year, send us the registration and we will confirm before you order.
Which seats does it take?
It takes seats drilled 345mm x 271mm (the Sparco and OMP seat pattern) and 405mm x 290mm (the Recaro seat pattern). If your seat is not listed, tell us what you run and we will confirm the fit.
Do I keep fore-and-aft adjustment?
Only with a sliding runner between the frame and the seat, which is a separate part on OMP frames. If more than one person drives the car, budget for the runner. Our guide to sliding runners explains the options and widths.
Base mount or side mount, and does it matter?
This is a base-mount frame: the seat bolts down through its base, the simpler stack that suits seats with a flat bottom and keeps the install low-fuss. Our guide on base mount versus side mount explains the whole fitting stack.
Is this for the driver or passenger side?
Both sides are available on this listing, pick driver or passenger side at the point of order (sides listed are for right-hand-drive cars). Left-hand-drive car? Ask us, as the sides swap over and availability varies by model.
