Which Seats Sit Lowest In An MG RV8, And Do The MGB Fittings Fit?
A customer asked us which replacement seats would put him as low as possible in his MG RV8, and whether the fittings match the MGB. We can answer the first part with published seat sizes and the second only halfway. No maker prints a seat-base-to-floor figure for these seats, and we hold no RV8 floor measurements, so this page gives you the sizes that are printed and tells you what to measure on your own car.
- Prices read from the live site, inc VAT
- Every size on this page is a figure printed on the product listing
- Where we hold no RV8 figure, the page says so and says what to measure

Three narrow classic seats, mounted fixed and with the headrest set low
£769inc VAT
- The Cobra Classic RS and Cobra Interlagos are both listed 725mm tall. The Corbeau Sportsman is listed 790mm with its headrest fitted.
- Runners add height under the seat, so a fixed mount sits lowest. Corbeau's listing says so, without a figure.
- All three seats bolt through the base at 291mm x 330mm, so a frame or plate sits between seat and floor.
- We hold no RV8 floor hole figures. Measure your factory rail holes and send them to us before you order.
Do the MGB fittings match the RV8?
Rover built the RV8 as a heavily modified MGB, in a run of 2,000 cars between 1992 and 1995. From the outside it looks like a Roadster, which is why owners ask whether MGB seat fittings carry across. We can’t give you a yes. Our own MGB Roadster seat guide gives the original car’s factory rail holes as 320mm apart, and we hold no matching figure for the RV8.
We haven’t measured an RV8 floor, so we won’t guess at one. Cameron needs the distance between your rail holes in both directions, centre to centre, and whether the holes carry captive nuts. With those numbers we can say whether a frame made for the MGB picks up your car.
| Item | What we hold | What to do |
|---|---|---|
| MGB Roadster factory rail hole centres | 320mm, from our MGB Roadster seat guide | Compare with your RV8 |
| RV8 factory rail hole centres | No figure we can publish | Measure both directions, centre to centre |
| Captive nuts in the floor | Unknown on your car | Check with a torch before ordering |
| Seat bolt pattern | 291mm x 330mm on all three seats below | Nothing to measure, it is on the listing |
Send your measurements by email or chat and we will check them against the seat you like.
What decides how low the seat sits
The shell is only one part of how high you end up sitting. Under it there’s the frame or plate and any runners, and on top there’s the headrest. Add all four up before you choose a seat. Garreth will go through the stack with you for your own car.
Runners
Corbeau's runner listing says a runner adds height under the seat and prints no figure. A fixed mount sits lower, and the cost is that the seat no longer slides.
Headrest
The Sportsman's 790mm is with the headrest fitted. The headrest can be left off, and Corbeau print no figure without it.
Frame or plate
The Corbeau Le-Universal frame comes with a pair of double locking runners, so it is not the lowest route. Ask us about a fixed mount for your car.
Seat shell
The Cobra seats are listed 725mm tall. Corbeau list the Sportsman at 790mm with headrest, and a base depth of 54cm.
Three narrow seats and what each one is listed at
The Classic RS has the narrowest base in the Cobra fixed back range, 340mm, and is listed 725mm tall, 490mm wide and 760mm deep at 8.7kg. It’s a fixed back with a separate adjustable head restraint, so you can set the headrest as low as it goes. The bolt pattern is 291mm x 330mm, base mount.
This listing is the leather seat. If your RV8 lives with the hood down, read Cobra’s own note: it says vinyl is the more sensible trim for an open car left outdoors. It’s listed as suiting all driver heights and waist sizes.
- From £769.00 inc VAT
- 340mm base, 725mm tall, 8.7kg
- Fixed back, base mount, 291mm x 330mm
- Separate adjustable headrest included
-
From £769.00 Incl. VATFrom £640.83 Excl. VATPayPal CreditKlarna ReadySelect options This product has multiple variants. The options may be chosen on the product page
Product cards show prices excluding VAT. Prices in the text include VAT.
The Interlagos Signature is Cobra’s narrowest reclining seat, with a 410mm base, listed 725mm tall, 500mm wide and 760mm deep at 7kg. So it’s the same height as the Classic RS, with a backrest that reclines. It comes in vinyl or leather, hand trimmed in the UK, and the headrest is included.
It’s base mount at 291mm x 330mm and listed for all driver heights and waist sizes. Cobra frames include the sliding runner, and a runner adds height, so tell us if you want the seat fixed.
- From £499.00 inc VAT
- 410mm base, 725mm tall, 7kg
- Reclining, base mount, 291mm x 330mm
- Vinyl or leather, headrest included
-
From £499.00 Incl. VATFrom £415.83 Excl. VATPayPal CreditKlarna ReadySelect options This product has multiple variants. The options may be chosen on the product page
Corbeau call the Sportsman one of their smallest reclining seats, with a 40cm base and a maximum overall width of 41.5cm. Their published height is 79cm with the headrest fitted. The headrest comes as standard and can be left off, and the seat sits lower without it, though Corbeau give no figure.
It’s a four point harness compatible recliner without FIA approval, base mount on a 291mm x 330mm pattern, in cloth, vinyl or leather with five piping colours.
- From £468.00 inc VAT
- 40cm base, 41.5cm overall width, 79cm with headrest
- Reclining, base mount, 291mm x 330mm
- Waist 32in to 36in or 36in to 38in
-
From £468.00 Incl. VATFrom £390.00 Excl. VATPayPal CreditKlarna ReadySelect options This product has multiple variants. The options may be chosen on the product page
| Seat | Base width | Overall width | Overall height | Bolt pattern |
|---|---|---|---|---|
| Cobra Classic RS Leather | 340mm | 490mm | 725mm | 291mm x 330mm |
| Cobra Interlagos Signature | 410mm | 500mm | 725mm | 291mm x 330mm |
| Corbeau Sportsman | 400mm | 415mm | 790mm, headrest fitted | 291mm x 330mm |
Figures are as printed on each listing. Cobra and Corbeau measure height their own way, so ask us before you treat a 65mm gap as exact.
From the listed dimensions, drawn at 0.7 pixels to the millimetre.
From the listed dimensions. The listings give the pattern as 291mm x 330mm and do not say which way round it sits in the car, so use it to match a frame and not to read the floor.
Frames and runners: what sits under the seat
Drop us an email or click to open a chat with your rail measurements, and we will say which frame suits your RV8 and whether it can go in without runners. The three parts below are the ones we list for these seats, and each one is priced for the quantity named on its listing.
-
From £216.00 Incl. VATFrom £180.00 Excl. VATPayPal CreditSelect options This product has multiple variants. The options may be chosen on the product page
The Corbeau Le-Universal frame is for cars Corbeau do not list, and it comes with double locking runners for one seat, priced per frame. The two runner pairs are both sold as a pair for two seats, and the 291mm in the name is a handle width rather than a bolt spacing. Cobra’s listing and Corbeau’s describe that number differently, so tell us the seat and car and we will confirm which runner you need.
When the aim is to sit low we count every millimetre the plate and runners take up. If you drive the car alone, Cameron will talk through leaving the runners out.
Common questions
Which seat sits lowest in an MG RV8?
No maker prints a seat-base-to-floor figure, so we cannot rank them that way. By listed overall height the Cobra Classic RS and Interlagos are 725mm, and the Corbeau Sportsman is 790mm with its headrest fitted. The mounting under the seat then changes the result, so we work it out with your measurements.
Do MGB seat fittings fit an RV8?
We cannot confirm it. We hold the MGB Roadster’s factory rail holes as 320mm apart and no RV8 figure. Measure your holes in both directions, send them to us, and we will check them against a frame.
Will runners raise the seat?
Corbeau’s runner listing says a runner adds height under the seat and gives no figure. If you want the lowest position and only one person drives the car, ask us about a fixed mount.
Can I leave the headrest off?
On the Corbeau Sportsman, yes. The headrest is included as standard and can be omitted, and the seat sits lower without it. The Cobra Classic RS has a separate adjustable head restraint.
Will a tall driver fit these seats?
All three seats are listed as suitable for all driver heights. The Sportsman is sized for a 32in to 36in or a 36in to 38in waist. Give us your height and waist and Garreth will say which one he would sit you in.
Do I order one seat or two?
Each seat listing is for one seat. The Corbeau Le-Universal frame is priced per frame, so a driver and passenger set is two frames. The runner kits are sold as a pair.
Does this match our MGB Roadster guide?
The MGB Roadster guide covers the original car, with the Sportsman on runners. This page is for the RV8, and it keeps the 320mm rail figure as the thing to compare your car against. Read the MGB Roadster seat guide for the fuller story on the earlier car.
What we would buy
Garreth
Garreth's top tip
For an RV8 where you want to sit low, I'd take the Cobra Interlagos Signature in vinyl, at 725mm tall. It's the narrowest Cobra recliner at 410mm, and vinyl is the trim Cobra suggest for an open car.
If you want the narrowest base of all, I'd put you in the Classic RS at 340mm.
Cameron
Cameron's fitting view
I want the rail holes on your car measured both ways, because the frame has to land on them. Then I add up the stack under the seat and see if we can leave the runners out.
Send me those numbers and I'll tell you straight what goes in and how low it'll sit.
Want us to check a seat against your RV8?
Tell us your rail hole centres and how much height you have under the screen frame. Cally, our digital receptionist, takes your details, and Cameron comes back to you with what fits.





